Revision date: 26.02.2013 Page 8 of 32
4 INSTALLATION
Only qualified personnel should perform this installation.
Only personnel that have read and understood this Manual should install and operate this equipment.
The machine must only be plugged into a receptacle which is grounded per applicable electrical codes.
Note 1
The power switch is to be in the OFF position when installing work cable and torch and when connecting
power cord to input power.
Note 2
The parts behind the wire drive door are live when wire welding. Never open or leave this door open while
welding
SELECT SUITABLE LOCATION
The UWW-161TP has an IP23S rating. Locate the welder in a dry location where there is free circulation of
clean air into the back and out the front of the unit.
Ensure minimum 50cm free space from the back of the machine. If free flow of air is hindered the machine
will overheat.
A location that minimizes the amount of smoke and dirt drawn into the machine reduces the chance of dirt
accumulation that can block air passages and cause overheating.
AVOID TILTING
The machine must be placed on a secure, level surface, maximum 10º out of horizontal.
ASSEMBLY
To the back panel
1 Primary connection 230V 50/60Hz 1phase
+ protective earth. 2,5m cable 3x2,5mm²
with plug is included
2 Gas Cylinder with Argon, Argon/CO2 or
CO2 (not included with machine)
3 Gas regulator with flow adjustment (not
included with machine)
4 Gas hose (not included with the machine)
5 Hose socket with nut and hose clamp for
6mm (1/4”) hose, included with the machine
Inside the machine
6. Spool of welding wire
(not included with the machine)
7. Wire feed roll V-groove for 0,6-0,8mm wire
To the front panel
8.a MIG torch (included with the machine) to the Euro-connection
- then select polarity to the Euro-connection with the cable and Dix-connector on the front panel.
- then connect the return cable to the other polarity. MIG torch is included with the machine
8.b TIG torch (not included with the machine) to the Euro-connection
- then select – (negative) polarity to the Euro-connection with the cable and Dix-connector on the front panel.
- then connect the return cable to the + (positive) polarity
8.c Electrode holder (included with the machine) for MMA welding to the + or – socket depending on the type of
electrode to be used
8.d Return clamp (included with the machine) for all processes to the free (+ or -) socket.
LED indicating that
protection against too high
input voltage has been
activated
Important!
To prevent overheating the machine requires at least 0,5 m
free distance at the back to allow free flow of cooling air.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals